Figure 9-23: Verify your configuration Figure 9-24: FortiView Sessionsġ4- Go to Log & Report> Event > SD-WAN Event. Figure 9-22: Status of Interfacesġ3- Open the browser in the Firewall Manager and type msn.com and then go to the Dashboard > FortiView Sessions. Figure 9-21: Verify Configurationġ2- Go to Network > SD-WAN and verify your SD-WAN Usage. You should be able to reach the Internet from Firewall Manager. Figure 9-20: SD-WAN usageġ1- Now, go to GN3 and disconnect port4. Add Target and leave the default parametersįigure 9-18: Create a SLA Figure 9-19: SD-WAN Configurationġ0- Go to Network > SD-WAN and verify your SD-WAN Usage. Table 9-2: Firewall Policy configuration NameĨ- Go to Network > SD-WAN Rule, create a rule as follows: Your interfaces in OpenWrt should be like figure 9-9: Figure 9-9: OpenWrt Interfaces Firewall Configurationġ- Set the port3 as a management port and connect it to Firewall Manager(Webterm-2) Then, submit and add IPv4: 10.200.3.254 netmask: 255.255.255.0įigure 9-6: Add a new interface (LAN3) Figure 9-7: IP Configuration for LAN3 Figure 9-8: Firewall settings for LAN3.And finally, under Firewall Settings select firewall-zone as Lanįigure 9-3: Add a new interface Figure 9-4: LAN2 IPv4 configuration Figure 9-5: Firewall settings for LAN2.Then, go to network> interfaces > Add new interface … You can type in the browser:, and click on “Login” without entering any password. So, you can set the WRTManager as 192.168.1.2/24 and connect to OpenWRT through the web browser. To configure OpenWRT, you should connect through port eth0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |